Apple iPhone Case Components - Page 6

Replace the mesh covers for the speaker, vent, and microphone openings. Mesh covers are part of the water and dust ingress protection for the phone.

This tray holds the nano SIM card and is inserted on the side of the phone.

Replace the gasket that seals the earpiece speaker mesh bracket assembly against the back of the earpiece speaker compatible with the iPhone 7 Plus model #A1661, A1784, A1785, A1786.

This metal bracket secures the front panel assembly cables and the battery cable to the logic board.

This metal bracket secures the camera flash to the rear case.

Replace a bent or missing metal bracket that secures the earpiece speaker to the back of the display assembly compatible with the iPhone 7 Plus model #A1661, A1784, A1785, A1786.

Replace the plastic bracket that holds the earpiece speaker opening mesh in place against the inside of the front panel assembly compatible with iPhone 7 Plus model #A1661, A1784, A1785, A1786.

Replace a scratched or missing camera flash diffuser lens.

Replace the mesh that covers the earpiece speaker opening compatible with the iPhone 7 Plus model #A1661, A1784, A1785, A1786.

Replace an external lens cover for the rear-facing cameras compatible with iPhone 7 Plus. Includes the metal bezel ring.

These plastic guides center the front-facing camera and the ambient light sensor over the openings in the front glass panel.

Replace a bent or missing metal bracket that secures the power switch to the inside of the rear case.

Replace a bent or missing metal bracket that secures the volume switches to the inside of the rear case.

Replace a torn or missing gasket on the SIM card tray for an iPhone 7 or iPhone 7 Plus.

Replace the mesh covers for the speaker, vent, and microphone openings.

Replace the internal clips that hold the external button covers in place. Set of three.

Replace the mesh that covers the earpiece speaker opening compatible with the iPhone 7 model #A1660, A1778, A1779, A1780.

Replace the spring contact that grounds the lightning connector assembly to the back of the home button bracket compatible with the iPhone 7 and iPhone 7 Plus.

Replace a metal bracket that secures the rear facing camera to the display assembly compatible with the iPhone 7.

This metal bracket secures the front panel assembly cables and the battery cable to the logic board.

This metal bracket secures the audio control and power button cable connector to the logic board.

Replace the metal bracket that secures the rear-facing camera connector to the logic board compatible with iPhone 7.

This metal bracket secures the camera flash to the rear case.

Replace a metal bracket that secures the earpiece speaker to the display assembly compatible with the iPhone 7 model #A1660, A1778, A1779, A1780.