iFixit Opening Picks set of 6

$4.95

Product code: IF145-123-2

Click Image To Zoom

 
 
 
 

iFixit Opening Picks set of 6

$4.95

Product code: IF145-123-2

Product Overview

Pick your way to repair!

  • 6 very thin opening picks
  • Can be used for prying, sliding, separating, and air guitaring.
  • These picks are especially useful for prying open iPads and other glue-laden devices.

Product Details

  • Material: Delrin
  • Dimensions: 38 x 36 x 0.5 mm

  $4.95

 

Condition:

New

Available: 50+

Add to Cart
 

Stories

My Problem

Cracked Screen

My Fix

Great!

My Advice

Becareful where you order your screens. I had to do this twice!!

My Problem

Kindle would not charge unless you did the wire dance ( moved it all over) until you find the spot that if you're lucky will charge after you sit it down . Got to the point that I had to do it without moving the Kindle.

My Fix

Very well, you just have to pay attention to details.

My Advice

Have a clean surface and all the parts you need before you do this and watch the video a few times to make sure you have it down.

My Problem

iPad 4th Gen WiFi with a broken front glass.

My Fix

The instructions were great except that for some reason, they assumed that I would be replacing an intact glass panel. Mine was broken in 4 lines, and every time I got to another break, it would shatter down to powdered glass and glue (Yes I know it is 3M tape).

My time estimate was off by a significant factor.

It will probably take me another hour to finish cleaning the surfaces before I can reassemble.

My Advice

Don't try to replace the glass unless you have a lot of time and a clean work surface.

My Problem

Screen was cracked, after replacing screen I found there was more wrong with the Samsung Core phone.

My Fix

Screen replacement went well

My Advice

Include instructions for the specific phone

My Problem

I needed more ram than my original 8 gb and wanted to stick in two 8 gb ram sticks

My Fix

The repair went great except for the fact that I didn't thoroughly plug in my screen and speaker connections.

My Advice

Check your connections before you tape the screen or it might go wrong and you'll have to reopen the screen

My Problem

My phone slipped from my hand and landed face-first on some pointy cobblestone street. Needless to say, the digitizer became useless, and I think some of the circuitry got damaged too, because the image was distorted

My Fix

Peeling out the back was more difficult than expected, and the tab that is supposed to help removing the battery connector was a tad too flimsy (it broke!, but you can take out the cable being a bit patient and not too forceful).

Also, I'm still trying to replace the speaker/microphone grills. They're rather difficult to insert!

My Advice

Yeah, don't let your phone drop! The replacement screen is rather expensive.

My Problem

Cracked LCD

My Fix

Success: About 3.5 hours.

Followed 2 iFixit repair guides:

1) Steps 1 - 16 for 17 inch Gloss LCD replacement:

MacBook Pro 17" Unibody LCD Replacement

2) Steps 21+ for 15 inch Matte LCD replacement, for the grey bezel:

MacBook Pro 15" Unibody Mid 2010 Matte LCD Replacement

Remember, the 15 screen internals are different from the 17 when it comes to the other screen parts, so refer back to the 17 guide (or video below) once the bezel is off.

My Advice

Use this extra YouTube video for reference, as it's got instructions on putting back together again:

https://www.youtube.com/watch?v=HLwO1YV5...

However, use this video as a supplemental (e.g. on iPad). Generally follow the iFixit method for disassembly (NB. remove the battery connector, remove the black rubber gasket around the bezel, etc, no need to remove hinges as in video).

Video is more useful for when putting things back together.

Notes:

- I put the black rubber gasket back on first, and then the bezel.

- Putting back the Clutch Cover (step 17, guide 1) can be quite tricky; see on the video it says to put the cable on top of the hinge (of the left), so that the bottom can sit in the body. Have a look at the groves in it to see how they slide left into the screen body.

- My bezel reassembly needs more glue/work; it's not as flush as original.

My Problem

iPad was discharging quickly. Then it would not charge at all. Would not turn on or charge (dead). Determined the battery needed replaced.

My Fix

Used the iFixit guide and was able to successfully repair. I used a hair dryer to soften the adhesive and was very patient (heat, cautiously pry, heat and pry, heat and pry). Once the glass was off the rest was fairly easy.

My Advice

The pictures of the retaining clips could be more clear, took a while to figure out the clips. Maybe an exploded view of the clips 'locked' and 'unlocked' would have helped. Other than that the guide was pretty thorough and accurate.

My Problem

se rompio el touch

My Fix

dificil ya que tuve que quitar los pedasitos de cristal

My Advice

usar herramientas ifixit para que sea mas sencillo la reparacion

My Problem

Kindle wouldn't turn on, but I still heard sound when I would turn it on, so I suspected it was the screen

My Fix

I was able to pull it apart using the guide, I replaced the screen and it turned on fine.

My Advice

It was a lot easier than I thought it would be.

 

Related Questions