iPhone 7 Display Assembly Replacement

Step 1 Display Assembly




• Use the flat end of a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board.
• To reconnect these cables, press down on one end until it clicks into place, then repeat on the opposite end. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.
Step 2




• Remove the two 1.3 mm Phillips screws securing the bracket over the front panel sensor assembly connector.
• Remove the bracket.
Step 3
• Disconnect the front panel sensor assembly connector from its socket on the logic board.
• This press connector should also be reconnected one end at a time to minimize the risk of bending.
Step 4
• Remove the display assembly.
• During reassembly, pause here if you wish to replace the adhesive around the edges of the display.

Author

with 4 other contributors

Evan Noronha

Member since: 02/05/15

223,475 Reputation

168 Guides authored

Badges: 49

• 
• 
• 

+46 more badges

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview