Introduction
The entirety of the Moto 360 is very fragile. Take extreme caution when using tools.
What you need
-
-
Set the watch face down on a flat surface.
-
Place the heated iOpener on the face of the rear cover to loosen the adhesive underneath.
-
-
-
Follow the instructions here to remove the back cover without force by using some needles in the right places:
-
Then continue with step 5. Or don't use needles and just continue with the next steps.
-
-
-
Gently slide the blue opening pick between the rear cover and the metal casing.
-
Work your way entirely around the rear cover.
-
-
-
-
Set the Moto 360 face up on a flat surface.
-
Place the iOpener on the face of the device screen.
-
-
-
Gently slide the opening pick between the screen and the metal casing.
-
Work your way around the face of the screen, loosening the adhesive.
-
-
-
Detach the copper ribbon connecting the motherboard to the display.
-
For reassembly, attach copper ribbon where it is marked.
-