Parts

No parts required.

Pull the plug!
  • Pull the plug!

  • Remove the drip tray, the water tank and the pulp container.

Add Comment

The back panel and side panels are attached with six phillips screws PH2. Screw it out. The back panel and side panels are attached with six phillips screws PH2. Screw it out.
  • The back panel and side panels are attached with six phillips screws PH2. Screw it out.

Add Comment

Slide the right side panel about 2 cm to the back. Then solve it.
  • Slide the right side panel about 2 cm to the back.

  • Then solve it.

Add Comment

New Battery = Faster iPhone
Fix Kits starting at $16.99
The left side is a bit stuck. Place a plastic opening tool in the gap between the front and left side panel above the opening for the water tank. Lift the gap slightly larger. Then place the tool in the gap between the front and left side panel under the opening for the water tank. Increase the gap and push the side part about 2 cm to the rear. Lift out the left side piece.
  • The left side is a bit stuck. Place a plastic opening tool in the gap between the front and left side panel above the opening for the water tank. Lift the gap slightly larger.

  • Then place the tool in the gap between the front and left side panel under the opening for the water tank. Increase the gap and push the side part about 2 cm to the rear.

  • Lift out the left side piece.

Add Comment

Take out the back
  • Take out the back

Add Comment

The front panel is secured with four PH2 Phillips screws, two left and one right each. Turn it out. Use a plastic opening tool to lever off the steam tap. Carefully pull the front panel about 1 cm forward so that there is a gap between the top cover and the front panel,
  • The front panel is secured with four PH2 Phillips screws, two left and one right each. Turn it out.

  • Use a plastic opening tool to lever off the steam tap.

  • Carefully pull the front panel about 1 cm forward so that there is a gap between the top cover and the front panel,

  • Do not pull the front panel too far, it is still attached with different hoses and cables.

Add Comment

Two Phillips screws PH2 hold the lid at the back. Turn it out. Lift the lid upwards. Lift the lid upwards.
  • Two Phillips screws PH2 hold the lid at the back. Turn it out.

  • Lift the lid upwards.

Add Comment

Conclusion

Repeat the steps in order to reassemble your device.

One other person completed this guide.

Special thanks to these translators:

100%

irlanda is helping us fix the world! Want to contribute?
Start translating ›

VauWeh

Member since: 10/19/2015

25,222 Reputation

33 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 12

Past 30 Days: 50

All Time: 86