Released April 2010 / 2.4, 2.53 GHz Core i5 or 2.66, 2.8 GHz Core i7 Processors

482 Questions View all

Reverse steps for replacing front panel glass

I used ifixit guide for this glass replacement after purchasing a replacement glass and tools from ifixit. My new glass however keeps sliding down when the MacBook Pro is open, i.e. with the screen in the upright position. I did not apply the heat gun in the reverse of step 17.

My questions are

1. Should I apply the heatgun to get the glue to take properly.

2. If yes to 1, so I need to disassemble the MacBook Pro to do this, or can I just do it on the fully assembled unit.

Thanks

Mike

Answer this question I have this problem too

Is this a good question?

Score 1

Comments:

Is this issue resolved?

by

Add a comment

1 Answer

Most Helpful Answer

You can purchase extra strong double sided sticky tape to hold the glass in place.

Was this answer helpful?

Score 1
Add a comment

Add your answer

mbrislin will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 725