I am replacing the screen and digitizer to my Samsung S7, but i cannot get it to sit flush with the frame. The frame does not appear to be warped or bent… not sure what to do. Same thing happened when I replaced a screen to a S5..and now the edges are coming up. Advice is appreciated!
Is this a good question?
Rep: 805
7
3
The pre-applied adhesive that comes with these screens are terrible! Either use industrial double sided tape or adhesive. Make sure to clean the old adhesive off the frame when the replacing it.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 3
All Time: 68
Did you put some adhesive on the edges?
by Jesse Hooton