Rep: 195
4
4
Hi
I have the above error in diagnostics. It appears to point to LCD Temperature Sensor. I have tested another LCD with my Mac and it isn't the LCD itself. This results in fans running at full speed as well as LCD Proximity reading as - in istat menu app.
Any help would be appreciated
Thank you
Is this a good question?
Rep: 480.2k
35
329
971
The error TLOp points to: ''Excessive LCD panel area temperature, Verify that the DisplayPort cable is securely connected to both the LCD panel and the logic board. This is straight out of the Apple manual.
I would say since you tried a second display and it too showed the error that points to the LVDS connector on the logic board its self the contact within it has a problem, the solder joint of the connector or the rest of the sensor logic within the logic board needs to be investigated.
Was this answer helpful?
Rep: 685.4k
3.4k
1.1k
2.6k
I would first check that the the LCD thermal sensor cable connector is correctly in place. See step #8 of this guide:
Was this answer helpful?
The thermal sensor cable and connector looks fine. I've examined the pins inside the connector too and they look fine.
I do suspect the lvds connector now that Dan has mentioned it. There's a pin that looks slightly out but because it was working I didn't suspect it. But the more closely I examine it the more I think it is the LVDS connector on the logic board.
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 8
All Time: 394
