panel locked lite on washer will not start
whirlpool washer Mod#GHW9400PW4 control lock light is on,but the other panel lights not working,machine wont start.any idead?
Steve
Is this a good question?
Score
0
460039
3 Answers
Most Helpful Answer
Rep: 685.3k
3.4k
1.1k
2.6k
Try unplugging it for five minutes to allow it to reset. Then when you plug it back in watch for any error codes.
Was this answer helpful?
Score
4
I un-pluged it for 24hours the only lite that comes on is the lock and unlock control,i hold it down for 3 seconds the lite will go off but no other lites will come on even when i hold the control botton down.
Steve
Try this diagnostic test: How do I remove the Control Locked light which prevents starting
After trying all that “unplugging and re-plugging” and pushing “End of Cycle” button, as well as all the other buttons, my Whirlpool Duet Washer, Model WFW9600TW01, still displays the “red light” underneath the Controls Lock/Unlock button on this front load machine. With the machine in the “Controls Lock” mode, it will not ‘power on’ and operate. Solution: Replace the user left-most, user interface, circuit board! For my washer, Whirlpool no longer makes the user interface, parts (nor replacement parts), so good luck getting a refurbished board? You can always get your original, circuit board rebuilt. Regards, Jimmy
Was this answer helpful?
Score
0
i'm having trouble with my whirlpool top loader washing machine i just gotten repaired yesterday with a new motor and i also recalibrated too but during the recalibration cycle i noticed all the lights were on except the locked button, and that had me puzzled cause i'm thinking it recalibrated but once finished and i try to start a batch of clothes and i push the start button the locked button comes on pleae help what can i do?
thank you 😊
Was this answer helpful?
Score
0
