Inverter replacement socket problem
I just replaced the inverter and now I've started reassembling, starting back thru the steps; got to 32 - replacing the antenna cables and the inverter cable socket;
the issue is with the socket; it doesn't seem to have anyplace to plug back into; the instructions say to be careful not to pull the whole thing off the board; so...
1. I'd like to figure out how to plug it back in where it doesn't look like there's a place to plug it back into
2. I'd like to know if there's a 'fix' for where you've pulled the whole thing off - if that's what I did;
Is this a good question?
3 Comments
A couple of photos of what you're looking at might help us determine your issue.
by mayer
photo sure: hope it is somewhat clear[image|679665]
by irvinebobb
hope that added an image; I can't tell
by irvinebobb