Rep: 13
1
In the process of removing the logic board the power switch cable was unintentionally ripped from the back of the power switch. Is there any way to remove the switch so I can attempt to resolder the wire to the switch?
Is this a good question?
Rep: 685.3k
3.4k
1.1k
2.6k
That switch is usually held in place by 3 plastic globs that are integrated into the back frame. I have used a chisel to break them off and then re-glued it back into place after replacing. It not a pretty repair, just a hack.
Was this answer helpful?
This answer is not a very good It is very silly
Well Manuel, just how do you proposed to repair it? Have you even looked at one?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 1
All Time: 231
1 Comment
Did this solution work? I have the same problem. Any tips?
by kbranch