router is not responding

problem : router's wifi status light is on but no wifi signal.

2. Can not connect to router via LAN cable also, on lan serup mode , page not available. On ipconfig, device ip : but default gateway ip is missing .

3. Ping to is not working

4. Router stopped working after i tried setting it in repeater mode(as acess point to my root dlink router)

Reset to default factory mode is not working.

pls help. Thanks

Answered! View the answer I have this problem too

Is this a good question?

Score 0
Add a comment

4 Answers

Chosen Solution

Most of these must be accessed via Ethernet cable to set up - so set it up next to your computer. Factory reset should work, go over the directions again. Configuring two routers (or more) on a network is advanced networking. If possible (don't need wireless) a simple Ethernet Hub is easier to configure.

If this Answer is helpful please remember to return and mark it Accepted.

Was this answer helpful?

Score 2


thanks for response...

All hope was on factory reset... seems it is not working...

I tried holding it for 20-30 secs... and did it multiple times...

is there any other way can solve this problem.....


There are five steps follow them all. Also you will find several other useful links at the bottom of the linked page. - For future reference you posted a comment in the place where only Answers belong. Please use the Add Comment link, or update your Question.


Add a comment

You can try by resetting your router and re-configure it again. Please note that your all saved setting shall gone once you have done hard reset so i would suggest if your using ADSL then get your PPPoE account setting from your ISP first and then do this.

Was this answer helpful?

Score 0
Add a comment

If you are using as the default ip address of the Netgear router login, you can probably do several functions from your browser. Once you have logged in to the router and get configuration page, you will have following possibilities to do.

• You can easily change a default username and password of the Netgear router to enhance the level of security in your home network. At the same time, you can also adjust the settings such as DHCP settings and encryption.

• Configuring your router device is also simple using this ip address.

• Similarly, you can also modify the entire LAN network system.

Was this answer helpful?

Score 0
Add a comment

When your router is not working there can be several reasons behind this problem:

1. Physical Connection Problem.

2. Internet Connection Problem.

Before doing any troubleshooting steps into your computer, you need to make sure that you are getting internet on your modem. so you need to connect your modem directly to the router and try to access the internet. if you can access the internet from your modem, but can't access the internet from your router. i will suggest you to visit : why my netgear router has stopped working

Was this answer helpful?

Score 0
Add a comment

Add your answer

Puneet will be eternally grateful.
View Statistics:

Past 24 Hours: 1

Past 7 Days: 10

Past 30 Days: 44

All Time: 979