Skip to main content

You're viewing a previously published version of this guide.  View latest version

Older Newer

Introduction

Prerequisite guide for disconnecting the battery before performing any repair.

Parts

No parts specified.

  1. To avoid stressing any cables, hold the display assembly perpendicular to the body of the iPad until it is disconnected.
    • To avoid stressing any cables, hold the display assembly perpendicular to the body of the iPad until it is disconnected.

    • Remove the four 1.2 mm Phillips screws over the battery/display connector bracket.

  2. Remove the battery/display cable bracket.
    • Remove the battery/display cable bracket.

  3. When disconnecting any press connectors from the logic board, be sure to lift the connector straight up to avoid ripping the socket off the board. Use the flat tip of a spudger to disconnect the battery connector from its socket on the logic board.
    • When disconnecting any press connectors from the logic board, be sure to lift the connector straight up to avoid ripping the socket off the board.

    • Use the flat tip of a spudger to disconnect the battery connector from its socket on the logic board.

    • Bend the battery connector ribbon cable up slightly to prevent it from making contact and powering on the iPad.

Evan Noronha

Member since: 02/05/2015

209,581 Reputation

178 Guides authored

Team

iFixit Member of iFixit

Community

140 Members

17,046 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 7

All Time: 152