Introduction
Basic instructions: remove the back panel on the Siemens Surpresso - Bosch Benvenuto
What you need
-
-
Remove the seven Torx T10 screws on the rear panel.
-
Lift the back panel away.
-
Remove the two flat plugs from the inside of the power switch.
-
-
Almost done!
Follow the steps in reverse order to reassemble your device
Conclusion
Follow the steps in reverse order to reassemble your device
Special thanks to these translators:
de en
100%
oldturkey03 is helping us fix the world! Want to contribute?
Start translating ›