Introduction
Most repairs start with the removal of the rear cover. This one is fastened with two screws on the bottom and two bayonet-like locks on the top.
These instructions may also help with other Saeco models and with coffee makers from Philips and Gaggia—they are all made by the same manufacturer and have a very similar design.
What you need
-
-
-
Remove all accessory parts like the water reservoir, the brewing assembly as well as the drip try.
-
Remove all coffee beans from the bean container
-
Remove the two T10 Torx screws from the bottom of the rear cover.
Ask FixBot
-
-
-
-
Pull the back cover approximately 1 cm (3/8inch) out from the bottom and push it in an upward direction.
-
-
To reassemble your device, follow these instructions in reverse order
Cancel: I did not complete this guide.
One other person completed this guide.
Special thanks to these translators:
100%
These translators are helping us fix the world! Want to contribute?
Start translating ›
