Skip to main content

You're viewing a previously published version of this guide.  View latest version

Older Newer

Introduction

If your Hover-1 Rally (model H1-RALY) scooter will not accelerate, use this guide to replace the acceleration lever. The acceleration lever is located next to the right handlebar grip and is easy to replace. Replace this part if it is damaged or immovable.

Make sure to power off the scooter before starting this guide.

  1. Remove one 4 mm Phillips #1 screw located directly above the acceleration lever.
    • Remove one 4 mm Phillips #1 screw located directly above the acceleration lever.

  2. Turn the right handle grip counterclockwise. The right handle will disconnect from the handlebar, exposing the acceleration lever.
    • Turn the right handle grip counterclockwise.

    • The right handle will disconnect from the handlebar, exposing the acceleration lever.

  3. Remove four 2 mm Phillips #00 screws located on the acceleration throttle.
    • Remove four 2 mm Phillips #00 screws located on the acceleration throttle.

  4. Pull the acceleration lever off of the handle.
    • Pull the acceleration lever off of the handle.

    • The acceleration lever sits perpendicular to the handle.

Van Schneider

Member since: 02/10/2020

109 Reputation

1 Guide authored

Team

Cal Poly, Team S7-G2, Regan Winter 2020 Member of Cal Poly, Team S7-G2, Regan Winter 2020

CPSU-REGAN-W20S7G2

6 Members

5 Guides authored

View Statistics:

Past 24 Hours: 1

Past 7 Days: 6

Past 30 Days: 31

All Time: 442