Introduction
This guide shows how to remove the paper eject frame assembly Constant paper jams might be caused by a faulty paper eject frame assembly. This process requires the knowledge of how to use basic tools.
What you need
-
-
Turn off the printer.
-
Disconnect all data connections coming into the printer such as USB, networkd cables, firewire, etc. as well as removing the power cord.
-
-
-
Locate the IEEE cover in the back.
-
Gently slide the cover to the right to unlatch, then pull to remove it.
-
-
-
Using a Phillips #2 screwdriver, remove the four 10 mm screws shown.
-
Remove the 6 mm screw that holds the rear housing in place.
-
-
-
Insert a plastic opening tool into the cutouts of the lower housing.
-
Release the two tabs of the side housing by lifting the tool in an upward motion.
-
Remove the side housing by pulling it outwards.
-
-
-
Remove the four 10 mm Phillips #2 screws from the sides of the printer.
-
Remove the three 6 mm Phillips #2 screws.
-
-
-
-
Hold the ink tube and draw out the waste ink tube by pulling on both tubes in opposite directions.
-
-
-
Using the #2 Phillips screwdriver, remove the last three 10mm screws securing the printer mechanism.
-
-
-
Remove the CD-R unit housing by releasing the two attaching points to the tray base.
-
Pull it outwards diagonally one side at a time.
-
-
-
Remove the left frame support plate by removing the two 6mm screws that secure it.
-
Pull it out by hand to free it.
-