Introduction
The spur gears can wear out or be destroyed if the blender binds. The exchange is very easy.
What you need
-
-
Here are the new spur gears. The spare part number at BSH is Bosch 00027660
-
-
-
-
The spur gears are fixed from above by a metal plate. This metal plate is inserted into a large plastic tab on both sides.
-
Gently push one of the two tabs outwards a little until the metal plate comes out of the slot.
-
Lift the metal plate complete with the controller and tensioner up and away and set it aside.
-
The two clamps for the stirring inserts are on top of the spur gears. Just lift them out
-
Work the steps in reverse order to reassemble your device.
Work the steps in reverse order to reassemble your device.
Cancel: I did not complete this guide.
2 other people completed this guide.
Special thanks to these translators:
100%
oldturkey03 is helping us fix the world! Want to contribute?
Start translating ›