Introduction
This repair will need:
A T8 Torx Screwdriver.
What you need
-
-
With the Generally Disassembly completed, you may proceed to floppy drive installation.
-
-
-
Reverse the computer to access the peripheral panel in the back.
-
Remove the two T8 Torx screws on either side of the bar code panel.
-
-
-
-
Reverse the computer to have the monitor and mousepad facing you.
-
Remove the plastic panel underneath the display.
-
-
-
Using a spudger, lift the plastic tabs on the floppy drive securing the ribbon cable to the ribbon port.
-
-
-
Replace the defective drive with a new drive.
-
Follow these instructions in reverse order to reassemble the device.
-