Introduction

This repair will need:

A T8 Torx Screwdriver.

  1. With the Generally Disassembly completed, you may proceed to floppy drive installation.
    • With the Generally Disassembly completed, you may proceed to floppy drive installation.

  2. Remove the plastic panel at the bottom of the display.
    • Remove the plastic panel at the bottom of the display.

  3. Reverse the computer to access the peripheral panel in the back.
    • Reverse the computer to access the peripheral panel in the back.

    • Remove the two T8 Torx screws on either side of the bar code panel.

  4. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  5. Reverse the computer to have the monitor and mousepad facing you.
    • Reverse the computer to have the monitor and mousepad facing you.

    • Remove the plastic panel underneath the display.

  6. Remove the three T8 Torx screws securing the floppy drive to the frame.
    • Remove the three T8 Torx screws securing the floppy drive to the frame.

  7. Using a spudger, lift the plastic tabs on the floppy drive securing the ribbon cable to the ribbon port.
    • Using a spudger, lift the plastic tabs on the floppy drive securing the ribbon cable to the ribbon port.

  8. Lift the defective floppy drive from the body of the computer.
    • Lift the defective floppy drive from the body of the computer.

  9. Replace the defective drive with a new drive.
    • Replace the defective drive with a new drive.

    • Follow these instructions in reverse order to reassemble the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Kevin Peters

Member since: 04/19/2011

114 Reputation

1 Guide authored

Team

Cal Poly, Team 20-66, Walters Spring 2011 Member of Cal Poly, Team 20-66, Walters Spring 2011

CPSU-WALTERS-S11S20G66

4 Members

3 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 4

All Time: 2,107