Options

Whirlpool ADG 201 - issue

Hi guys,

I was hoping you can help me.

I just got a Whirlpool ADG 201 dishwasher and set it up .

When I try to start a cycle, the on/off button starts blinking non stop and the second program (normal 65 degrees) is set disregarding the program I have set already.

I tried resetting the dishwasher by unplugging it but it did no good.

Also when I turn the water on for the dishwasher , it starts by itself and some water comes from the lower left side of the interior wall (there is a hole there).

Do you have any advice for me ?

Being an ADG 201 I only have 2 buttons (on/off and program) so any diagnostic cycles that I have read here don't apply to me because I cannon do them . Maybe somebody can help me with something for this model.

I have searched everywhere on the internet and couldn't find this.

Thank you

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0

2 Comments:

Hi @adypetzu ,

Is there a pattern to the On/Off light blinking, e.g. 7 blinks - pause - 7 blinks pause or 11 blinks - pause - 11 blinks - pause etc if you get what I mean?

by

Hi,

No, it is blinking non stop without pause.

Regards,

Adrian

by

Add a comment