After starting wash cycle , it fills with water then as agitation supposed to start get nothing but motor hum, then you have to manually select spin to get water to drain and spin out clothes
Dog ears look good as does drive motor coupler
Is this a good question?
Rep: 685.3k
3.4k
1.1k
2.6k
Cause 1
Agitator Repair Kit
If the washer won't agitate, replacing the agitator repair kit may solve the problem. The kit contains the agitator components that are most likely to wear out and/or fail. If any of the parts are worn out, stripped, or damaged, replace the kit.
Cause 2
Drive Block or Bell
The drive block connects the washer transmission to the agitator. If the drive block is worn out, the transmission shaft will still move back and forth, but the agitator will only move slightly or will not move at all. Inspect the drive block for damage. If the drive block is worn out, stripped, or damaged, replace it.
Cause 3
Motor Coupling
The motor coupling connects the motor to the washer transmission. If the washer is overloaded, the motor coupling will fail in order to protect both the motor and transmission. The motor coupling can also fail due to normal wear. Inspect the motor coupling to determine if it is broken. If the motor coupling is broken, replace it.
Was this answer helpful?
Already checked this as is in my question?
I f you checked it all, I have no answer.
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 219
