Hi I have a d7200 with a cracked bottom cover and purchased a replacement part to swap it out. The camera has no other damage and works fine. I was wondering how I would transfer the label with all the important information over to the new part.
Is this a good question?
Rep: 25
2
When removing a label (if it's just a sticker) it's always best to use some sort of heat gun or blow dryer to loosen the adhesive just enough so that you can either peel it off or (this is my preferred method) use a metal pry tool to separate it from the casing.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 2
All Time: 106
