Rep: 61
3
3
Replaced the LCD o a customers iPad Pro 12.9, solder job all done well but there's no touch. The LCD comes but but won't respond to my touch. Could it be a bad screen ?
Is this a good question?
Rep: 169
3
Check to make sure all the connectors are fully inserted. It is possible it is a bad screen but make sure everything is firmly connected and the ports inside are dust free.
Was this answer helpful?
Rep: 1
2
This problem mostly occur when tech connect LCD with battery connected and filter is blown 120Ohm 450mA near to Touch Connector.
Was this answer helpful?
Rep: 61
3
3
Got word that I might have blown the "power touch line" without schematics I don't know what to do :(
Was this answer helpful?
Rep: 121
2
2
1
If you didn't disconnect the battery while fitting the screen you have burnt out the touch filter unfortunately you need a multimeter and check for continuity
Was this answer helpful?
Past 24 Hours: 1
Past 7 Days: 2
Past 30 Days: 7
All Time: 2,727
