Fix Your Stuff Community Store

Repair information, troubleshooting tips, and guides for the sixth iteration of Apple iPhone, announced on September 12, 2012. Model: A1428, A1429

2522 Questions View all

Options

I replace the display of iPhone5 but the touch not function correct

I changed the display of my iPhone5 following all the instructions of the guide , at the end of the iPhone is turned on and seemed to work well , the touch response was good , then during use and opening the app I've seen that sometimes the touch it is as if it were not calibrated . It happens that the screen stops for a few seconds does not activate the touch but then at the end you unlock and it works all right . I also went to a service center that made me a diagnostic and saw that the display had been mounted properly and probably the Case Study was due to defective display. Can this happen ?

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest

Options

Is it doing this while it is NOT plugged in and charging?

If you're plugged in and charging your touch can be jumpy.

If not, you sure you seated the ribbons correctly?

Was this answer helpful?

Yes No
Score 0

3 Comments:

The dislpay respond to touch normally when you try to unlock it and entering the pin does not present problems. Navigating in the main screen is correct, the problem occurs when you go to open applications, from that moment the touch response becomes wrong and sometimes freezes. I tried to re-enter the flat but the situation is identical, also the screen is bright and without lines, the proximity sensor function properly, calls will not give problems.

I am increasingly convinced that the display may be defective

by

maybe the lcd screen replacement is faulty?

by

If the display works fine until you enter an app, sounds like an iOS issue.

Hold the power button until you see the 'Slide to Power Off' slider

DONT TOUCH IT

Instead, hold your home button until your screen flashes back to the springboard.

Then reboot your iPhone.

by

Add a comment

Add your answer

Daniele Di Tullio will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 2

All Time: 82