After putting a new screen on my 5s it kept showing the bsod so I decided to try to restore the phone but about 8 seconds after the progress bar not moving it shows the bsod and then gos back into dfu mode! And on the computer it shows that "error 9" is the problem but I changed the port that I was using to a different one on it and bought a new cable and tried it but still shows "error 9"
Any advice?
Andrew
Is this a good question?
Rep: 41k
15
78
89
Go to step 11 of this guide and compare the screw placement to the screws that you put back after the screen replacement.
If you mixed them up, you could have caused long screw damage.
To rule out other things, try to do a DFU restore (google it) with the front camera cable unplugged. What happens?
Was this answer helpful?
The screws were good and I followed the dfu restore but during the restore it dose the bsod and then reboots
Last thing you can try is a known good battery and try DFU restore after that.
I’ve seems defective screens do this, however unlikely. If that doesn’t work it could be a logic board issue.
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 86
1 Comment
This is probably due to the band chip being corrupt / faulty on the logic board. In most cases not worth repairing.
by Ben