my Kenmore washing machine 110.20422990, overflows with water while filling on the heavy duty setting, but does not overflow ( water shuts off properly) if set on delicate cycle ?
Is this a good question?
Rep: 685.3k
3.4k
1.1k
2.6k
Water Inlet Valve
If the washer is overflowing and power is shut off to the washer, the water inlet valve has failed. Replace it.
Pressure Switch
If the washer is overflowing the pressure switch might be defective. The pressure switch is attached to a small tube which is attached to the outer wash tub. As the water level rises the air pressure in the tube increases, once the set water level is reached the pressure switch turns off power to the water inlet valve. Check to be sure the air tube to the pressure switch is clear before replacing the switch.
Other Causes and Conditions
Low Water Pressure from House Supply
If the washer is overflowing the water pressure to the water inlet valve might be too low. The water inlet valve requires a minimum of 20 psi to shut off properly. If the pressure is lower, the valve may not close fully when the power is shut off. This results in the valve leaking water into the washer and causing it to overflow.
Was this answer helpful?
thank you for reviewing my question- to be honest, i had already read all the probable causes and how to's ( but i was hoping for a specific cause to my particular problem, since it only overflows on certain settings- not all settings). Thank you for trying to help me.
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 498
