Nerf N-Strike Elite Alpha Trooper CS-12 Troubleshooting

The trigger is pulled and nothing happens ¶ 

Silent but deadly does not apply here. Cue the crickets.

Magazine was not inserted correctly ¶ 

Make sure that the magazine was inserted all the way.

Slide Placement ¶ 

The slide should be pulled all the back and then returned to its original position.

Trigger is pulled but nothing comes out ¶ 

Is my aim that bad or did nothing come out?

Missing Darts/Magazine ¶ 

Make sure a magazine has been inserted and that it has darts in it.

Jammed Dart ¶ 

Open up the access gate on the top of the gun and manually remove the darts. If the dart is too far in to reach to reach by hand, insert a stiff wire through the access gate and down the barrel to push it out.

Wrong Darts ¶ 

This gun does not handle the suction darts well; it works best with elite darts. If the suction dart gets jammed, follow the instructions stated in the previous section to remove it.

Stuck Magazine ¶ 

How did I get it in here in the first place?

Magazine Release ¶ 

Pull the small orange button in front of the trigger guard. This button is the magazine release and should drop the magazine.

Slide Placement ¶ 

The slide must be pulled all the way back to allow the magazine release to be pulled.

Slide won't move back ¶ 

I like to move it, move it. This slide should take a lesson from those lemurs in Madagascar.

Already Loaded ¶ 

The gun has already been loaded. It's time to fire!

Jammed Dart ¶ 

There's a dart stuck in the barrel of the gun. Insert a stiff wire through the access gate and down the barrel to push the dart free.

Broken Hammer Rod ¶ 

The silver hammer rod is bent or broken. Follow the directions in this repair guide to remove the part.

Trigger is jammed ¶ 

Jam belongs in sandwiches, not your nerf gun.

Slide Placement ¶ 

Move the slide to the forward position in order to fire.

Broken Spring ¶ 

The spring that allows for the movement of the trigger could be broken. Follow the directions in this repair guide to remove the part.

4 Comments

i need help asap please whenever i prime my gun it goes back by its self and de-primes and i dont know what to do P.S. it has a orangemodworks mod kit installed

ShoeNugget - Reply

Slide will not go all the way forward so cannot fire any ideas how to fix it

Rob - Reply

i dont know what is wrong with it i shoot and the bullet comes out but it falls to the ground

jess - Reply

It doesn't handle used darts very well. Also, don't aim downwards as the bullet will slide out.

Hallvard Hvidsten -

View Statistics:

Past 24 Hours: 7

Past 7 Days: 27

Past 30 Days: 121

All Time: 5,479