Nylon Tipped Tweezers

Nylon Tipped Tweezers

$4.99

$4.99

We'll send a message when the product is back in stock.

Deck the Halls
With tools and Fix Kits

Repair Stories

User avatar

My Problem

The battery from Apple was holding about 17% of it's normal charge - the phone is pretty old at this point, so that's not surprising considering it's also a hand-me-down from my mother to me. I ordered the iFixIt Iphone 6 Battery Repair kit and it came in like 4 days, right when it said it would.

My Fix

Eve . . .

User avatar

My Problem

The piece of glass protecting the glass shattered overnight, and the camera became unuseable,

My Fix

Instead of removing the entire rear plate of the phone, I settled for my trusty hair dryer and heated up the adhesive on the broken glass and spent a tedious hour or so prying the broken pieces of glass and . . .

User avatar

My Problem

My battery was not holding a charge.

My Fix

Smoothly.

My Advice

Check out the videos and tutorial and do not be heavy handed. I found it stressful, worrying about breaking cables or connectors when disconnecting or reconnecting them. Removing the adhesive on the back of the battery correctly is also very important.

User avatar

My Problem

Speaker had blown and was not a pleasure to listen to any more.

My Fix

Step-by-step the repair guide was spot on. No surprises at all.

My Advice

Have plenty of light. There are lots of small parts in there.

User avatar

My Problem

Broken and dislodged foot pad is easier and cheaper to repair yourself.

My Fix

Simply repair. Took only about 5 minutes to clean the area and press the foot pad into place.

My Advice

Not necessary to remove the bottom of the computer case, but be certain the area is clean where the foot pad is inserted and that you li . . .

User avatar

My Problem

Your document is made for adding an additional SSD drive on a mid 2010 iMac i7. id 11.3

My Fix

Note:

1. There was one more screw, or 9 instead of 8 on the motherboard.

2. Sugestions: When you unscrew the screws on the motherboard, as sure to have inserted into the holes at the rear of the frame cable or USB . . .

User avatar

My Problem

Battery stopped holding a charge.

My Fix

Pretty easy - battery and tools seemed to be of good quality. The Mac now will hold a charge.

My Advice

Be very careful not to strip the screw heads... and be ready to clean out a lot of dust from the fan and other areas inside the case.

User avatar

My Problem

I needed to separate a very delicate LCD from UV bounded digitizer&glass, the problem with this is always the degree of heat you have to apply; without burning the LCD under it. It becomes twice as difficult when the frame is aluminum drawing heat away, demanding /more/ heat to get the glue to break . . .

User avatar

My Problem

Needed to open an iPod touch 4th Gen that was dropped.

My Fix

With the screen already damaged i didn't have be super careful with the glass, so i opened with a little more force to see were the threshold was. Remarkably solid compared to the screen on the iPad models and i am attributing that to the size of . . .

User avatar

My Problem

My iMacs hard drive failed

My Fix

The swap went quite well except for a couple of hickups. If I had everything set up, it would have only taken about an hour.

My Advice

I recommend that those who write instructions make note of connector orientations when required. when I disconnected the hd temperature sensor it po . . .

Show more