Introduction
Prerequisite-only guide for removing the speaker. Click here for the full speaker replacement guide.
What you need
-
-
Tool used on this step:Tweezers$4.99
-
Use a thin pry tool or tweezers to carefully pry up and disconnect the upper coaxial cable connector from the logic board.
Ask FixBot
-
-
-
Carefully de-route the coaxial cable you just disconnected from the small metal clip holding it to the logic board.
-
-
-
-
Use tweezers or the point of your spudger to pry both coaxial cables out of the metal clip holding them on the side of the speaker.
-
-
-
Remove the five Phillips screws securing the speaker:
-
Three 1.3 mm screws
-
One 2.3 mm screw
-
One 3.3 mm screw
-
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
