What you need
-
-
-
Use a JIS 00 screwdriver to remove the two 2.0 mm‑long screws securing the ground clip.
Ask FixBot
-
-
-
Use a JIS 00 screwdriver to remove the three 2.0 mm‑long screws securing the flex antenna.
-
-
-
-
Use your fingers or a spudger to swing the flex antenna out of the way to access the screws beneath it.
-
-
-
Use a standoff screwdriver to remove the two 4.0 mm‑long screws securing the Taptic Engine.
-
-
-
Use your fingers to flip the Taptic Engine out of its recess and onto the edge of the iPhone.
-
Hold onto the Taptic Engine during the next step to prevent straining its cable.
-
-
-
Use the point of a spudger to pry up the Taptic Engine press connector and disconnect it.
-
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
