Introduction

The WowWee MiP robot has a tendency towards short battery life. If the MiP seems too slow or stops responding, use this guide to change the MiP’s batteries. The MiP’s batteries are located in a battery pack on the robot's back.

  1. Remove the three 12.0 mm Phillips # 2 screws from the battery cover. Remove the three 12.0 mm Phillips # 2 screws from the battery cover.
    • Remove the three 12.0 mm Phillips # 2 screws from the battery cover.

  2. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  3. Carefully pull the battery pack from the robot. Remove the batteries from the battery pack.
    • Carefully pull the battery pack from the robot.

    • Remove the batteries from the battery pack.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Moira Keahon

Member since: 09/24/2014

166 Reputation

3 Guides authored

Team

9 Comments

Its a programmer MIP not this kind.

Azariah Trumble - Reply

Same question here, instructions needed for CODER MIP as it doesn't seem to be a holding a charge.

Gil Acosta - Reply

does spare battery adapter vailable(not reachargeable)

coolboyz' channel - Reply

Coder Mip Battery says fully charged - but Coder Mip doesnt turn on?

Sadie - Reply

Coder MiP one day old - was working - battery says fully charged - but Coder MiP doesn’t turn on? Any suggestions?

Sadie - Reply

View Statistics:

Past 24 Hours: 4

Past 7 Days: 21

Past 30 Days: 101

All Time: 8,630