Introduction

In our this guide, we will demonstrate how to replace the battery for the SONY RM-LVR1. This procedure consists of 3 simple steps. For optimal performance, fully charge the newly installed battery before use.

Parts

No parts required.

Use a Phillips #00 screwdriver to remove the four (4) screws on the back of the device.
  • Use a Phillips #00 screwdriver to remove the four (4) screws on the back of the device.

  • If the screws strips or is previously stripped, refer to the stripped screw repair guide.

Add Comment

Battery is the rectangular and silver object in the center of device.
  • Battery is the rectangular and silver object in the center of device.

  • Remove battery with finger by prying at the rear.

  • If unable to remove battery, pry out using spudger.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 15

All Time: 117