Introduction
The SodaStream Source creates soda when the loader tab is engaged. Pressing on this tab initiates carbonation and flavor infusion. This tab may become damaged through use and can be replaced through the steps given in this guide. The tab is located within the carbonating block and has its own cover. Replacement of the loader tab requires both external and internal disassembly of the device. This guide shows the steps to access this internal component.
What you need
-
-
Remove the soda bottle and the COâ‚‚ canister from the machine.
-
-
Tool used on this step:Phillips #1 Screwdriver$8.99
-
Remove the four 17.8 mm screws from the bottom metal base using a Phillips #1 screwdriver.
-
-
Tool used on this step:Phillips #1 Screwdriver$8.99
-
Remove the two 18.2 mm screws from the bottom of the front cover using a Phillips #1 screwdriver.
-
-
-
Push the brass bar, located in the top of the device, out of the carbonating block.
-
-
-
-
Remove the plastic piece, located near the front of the carbonating block, from both sides of the device using a plastic opening tool or nylon spudger.
-