Skip to main content

Fix Your Stuff

Right to Repair

Store

Introduction

Prerequisite-only guide to remove the midframe in a Samsung Galaxy S10e. The wireless charging coil and NFC coil are both included in the midframe.

  1. Remove the eight 3.9 mm Phillips screws securing the upper midframe to the phone.
    • Remove the eight 3.9 mm Phillips screws securing the upper midframe to the phone.

  2. Slide an opening pick under the bottom right corner of the upper midframe to separate the adhesive holding it to the lower midframe. Slide an opening pick under the bottom right corner of the upper midframe to separate the adhesive holding it to the lower midframe.
    • Slide an opening pick under the bottom right corner of the upper midframe to separate the adhesive holding it to the lower midframe.

  3. Insert the point of a spudger in the small cutout on the right edge of the plastic part of the upper midframe, near the Bixby button. Use the point of the spudger to pry the midframe up from the phone chassis.
    • Insert the point of a spudger in the small cutout on the right edge of the plastic part of the upper midframe, near the Bixby button.

    • Use the point of the spudger to pry the midframe up from the phone chassis.

  4. Lift the midframe by the plastic section and remove it from the phone.
    • Lift the midframe by the plastic section and remove it from the phone.

    • To reinstall, first insert the top edge of the assembly into the phone's frame, and then gently press down on the rest of the assembly to snap it into place.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Adam O'Camb

Member since: 04/11/2015

127,904 Reputation

378 Guides authored

Team

iFixit Member of iFixit

Community

134 Members

14,937 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 3

All Time: 40