Video Overview

  1. Heat the back cover to melt the strong adhesive sticker underneath.
    • Heat the back cover to melt the strong adhesive sticker underneath.

  2. Try to pull and open a gap between back cover and  frame after heat. Insert into a guitar pick to cut the sticker.
    • Try to pull and open a gap between back cover and frame after heat. Insert into a guitar pick to cut the sticker.

    • If you do it hardly, you need much more heat especially the edged side.

    • Slipping a playing card through the gap is a good way to loosen up the adhesive.

    • Remove the back cover. The white stripe is the sticker.

Conclusion

To reassemble your device, follow these instructions in reverse order.

42 other people completed this guide.

Sophia

Member since: 03/25/2014

41,189 Reputation

62 Guides authored

7 Comments

What about putting the one back on?

rcf917 - Reply

will it go back on and stay on without new adhesive?

dfasdfjiun - Reply

I suggest that you take new adhesive, old adhesive is not strong enough to hold back cover.

Witrigs -

You can check this video of put it back battery cover : https://www.youtube.com/watch?v=3HrmeVGY...

Witrigs - Reply

How do I remove the sticky part

Marcelino Lopez - Reply

View Statistics:

Past 24 Hours: 38

Past 7 Days: 200

Past 30 Days: 846

All Time: 98,439