Samsung Galaxy Book Pro 360 15" Rubber Feet Replacement

Introduction

Use this guide to replace the rubber feet in your Galaxy Book Pro 360 15" laptop with a genuine Samsung part.

Before you begin, refer to the Samsung PC Repair Guide for safety information.

What you need

Step 1 Access the rubber feet

Samsung Galaxy Book Pro 360 15" Rubber Feet Replacement, Access the rubber feet: step 1, image 1 of 2

Samsung Galaxy Book Pro 360 15" Rubber Feet Replacement, Access the rubber feet: step 1, image 2 of 2

Before you begin, shut down your laptop and unplug it.
Close the screen and lay your laptop down with the rear case facing up to access the four rubber feet.

Edit

Step 2 Remove the rubber feet

Samsung Galaxy Book Pro 360 15" Rubber Feet Replacement, Remove the rubber feet: step 2, image 1 of 3

Samsung Galaxy Book Pro 360 15" Rubber Feet Replacement, Remove the rubber feet: step 2, image 2 of 3

Samsung Galaxy Book Pro 360 15" Rubber Feet Replacement, Remove the rubber feet: step 2, image 3 of 3

Insert an opening pick between the rear case and the rubber foot.
Pry up with the pick and dislodge the foot from the rear case.
Use tweezers or your fingers to remove the rubber foot.
Repeat this process on the remaining rubber feet.
There are two types of rubber feet for this laptop. During reassembly, make sure the top feet say "M4" and the bottom feet say "M1".
To reinstall a rubber foot, align it over the recess and push down until it's secured.

Edit

Conclusion

To reassemble your device, follow the instructions in reverse order and perform the opposite actions, e.g., "reattach" instead of "removing." Skip steps that use heating and prying, and pay close attention to the 📌 bullets as you work through the steps.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Check out our Answers community for troubleshooting help.