Samsung Galaxy A3 Display / LCD Replacement

Step 1 Display / LCD

• Heat up the edges of the display with a heat gun or iPad opener.
Edit
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 2



• Using a pick or slim plastic tool, work around the edge of the frame to loosen the glass.
• Watch out for the ear speaker, camera and light sensor on the top of the phone.
• When working the glass free around the bottom of the phone, slide the tool out to avoid damaging the left and right home buttons (as shown in picture 2).
• NOTE: The LCD is also glued to the frame and will most likely break when removing the display.
Edit
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 3
• Once the display has been disconnected, lift the top of the display away from the phone to expose the home buttons (Shown in green)
• Pry the contacts gently off the underside of the glass and push them back into the recesses on the phone (shown in yellow).
Edit
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 4
• Connect the new display and seat it in the phone, without removing the plastic for the adhesive.
• Turn the phone on to make sure the display and home buttons work. If you glue the display without testing it first, it's a pain to take it off again once it has been glued and runs the risk of the display breaking.
• If the display works, remove the plastic covering the adhesive and seat the display in the phone. Push gently around the edges to ensure a good seal
Edit
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment

Author

with 4 other contributors

Harvey

Member since: 02/15/16

5,193 Reputation

10 Guides authored

Badges: 15

• 
• 
• 

+12 more badges

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview