Retroid Pocket Flip Back Plate Assembly Replacement
Kristen Gismondi and one other contributor
Last updated on Aug 19, 2026
Views: 364
View statistics:
- Past 24 Hours:
- 4
- Past 7 Days:
- 27
- Past 30 Days:
- 98
- All Time:
- 364
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓Use this guide to replace the back plate assembly on your Retroid Pocket Flip, or as a prerequisite to access the internals.
What you need
Tools
-
Spudger4.9
-
-
-
-
-
Remove the four 5.9 mm screws from the backplate of the device with a 1.3mm hex screwdriver.
-
Use a plastic opening pick to carefully separate the back cover from the device.
Ask FixBot
-
-
-
-
Use a plastic spudger to carefully lift and disconnect the battery connector.
-
Use tweezers to disconnect the connector from its socket.
-
-
To reassemble your device, follow these instructions in reverse order.
