Skip to main content

Fix Your Stuff

Right to Repair

Store

You're viewing a previously published version of this guide.  View latest version

Older Newer

Introduction

Install an Airport Extreme 802.11g card internally.

  1. Use a coin to turn the battery locking screw 90 degrees to the right.
    • Use a coin to turn the battery locking screw 90 degrees to the right.

    • Lift the battery out of the computer.

  2. Flip down the door on the right side of the battery compartment.
    • Flip down the door on the right side of the battery compartment.

  3. Use a spudger or flathead screwdriver to disconnect the Airport antenna from the card.
    • Use a spudger or flathead screwdriver to disconnect the Airport antenna from the card.

  4. Grasp the plastic tab and pull the card out all the way.
    • Grasp the plastic tab and pull the card out all the way.

Attached Documents

iRobot

Member since: 09/24/2009

1 Reputation

648 Guides authored

View Statistics:

Past 24 Hours: 2

Past 7 Days: 10

Past 30 Days: 24

All Time: 20,206