Palm m105 case replacment

Introduction

This guide demonstrates how to replace the case of your Palm m105. The case on the Palm m105 can be easily removed, and a replacement shell casing can be used to replace your damaged one.

Before you begin this repair, power off your device and make sure it's unplugged from the charger.

What you need

Step 1 Palm m105 case replacment

Palm m105 case replacment, Palm m105 case replacment: step 1, image 1 of 1

Remove the protective flip lid of the device. Open the lid and pull.
There are two clips that will pop out.

Edit

Step 2

Unclip the tab at the top of the device, to remove the face plate.

Edit

Step 3

Remove the batteries by opening the battery compartment on the back of the device.
Remove one battery at a time.

Edit

Step 4

Using a T-5 Torx screwdriver, remove all four screws at the back of the device by turning them counterclockwise. A sample screwdriver is located here.

Edit