Introduction

Use this guide to remove the midframe on your Motorola Droid Turbo.

Image 1/1:
  • Prepare an iOpener and lay it over the rear case to soften the adhesive on securing the rear case to the phone.

Add Comment

Image 1/2: Remove the rear case. Image 2/2: The wireless charging coil may try to stick to the rear case, so make sure to remove it from the case before fully separating the rear case from the rest of the device.
  • Use a plastic opening tool to pry the rear case off of the rest of the device.

  • Remove the rear case.

    • The wireless charging coil may try to stick to the rear case, so make sure to remove it from the case before fully separating the rear case from the rest of the device.

Add Comment

Image 1/1:
  • Remove the midframe bezel.

Add Comment

Image 1/1:
  • Remove the four Torx T5 screws securing the midframe plate.

Step 4, there are also 2 T shaped tabs on the sides locking the mid frame plate. Above them you can see an angled hole where you can insert a paper clip to push them out and up to unlock them.

Mike Mangiaruca - Reply

Image 1/1:
  • Remove the midframe.

There's two clips to the left and the right of the midframe. Use a SIM tool and insert them into the holes above the clips, and push the clips out from the inside. Once both have been pushed the midframe is released.

rkarnes1988 - Reply

Many ANY thanks for that additional tip. Rather important!

Nate Baxley -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Geoff Wacker

Member since: 09/30/2013

57,529 Reputation

109 Guides authored

One Comment

Which circuits depend of the midframe?

gabriel.mourasant - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 9

Past 30 Days: 40

All Time: 456