Introduction

The Linskys WAP54g is not a very complex guide and is basically composed of the outer casing and the circuit board. This guide is pretty simple but will require the removal of a few screws and prying apart the casing. Note that taking apart the casing will void your warranty for this device.

Parts

No parts required.

Image 1/1:
  • Power down and unplug the device.

Add Comment

Image 1/1:
  • Start by removing the two black rubber stoppers that act as the cushions to the legs of the device. The stoppers are located on the bottom towards the front of the device.

Add Comment

Image 1/1:
  • Once removed two small screws will be visible. With a small screwdriver unscrew the screws.

Add Comment

Image 1/1:
  • Remove the blue front panel from the rest of the device. You can now see the main board.

Add Comment

Image 1/1:
  • Now slide the bottom panel forward and remove it so the main board is attached to the bottom panel.

Add Comment

Image 1/1:
  • From here, remove the wires and nuts connected to the back panel of the casing by pulling the nuts through the holes in the casing.

Add Comment

Image 1/1:
  • Once the bottom panel is removed unscrew the screws from the main board to the bottom panel so the main board is independent of the bottom panel.

Add Comment

Image 1/1:
  • From here, all of the pieces of the casing are removed and the main board is independent of the entire casing.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Derek Myers

Member since: 10/04/2011

222 Reputation

5 Guides authored

Team

Cal Poly, Team 21-21, Maness Fall 2011 Member of Cal Poly, Team 21-21, Maness Fall 2011

CPSU-MANESS-F11S21G21

5 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 1

All Time: 1,659