Parts

No parts required.

Remove the plastic outer housing using your hands or a standard spudger.
  • Remove the plastic outer housing using your hands or a standard spudger.

  • Important! Note the three alignment pins on the inner part of the housing. When reassembling, take special care to line these up and insert the pins into the receivers on the chassis prior to snapping the edges into place.

Add Comment

Use your hands to carefully remove the outer frame to expose the inner components of the speaker.
  • Use your hands to carefully remove the outer frame to expose the inner components of the speaker.

Add Comment

Go around the outer edge of the side passive driver with a screwdriver to remove the seven 8.9mm Phillips #00 screws from both sides of the device. Make sure to set the screws aside somewhere they won’t get lost.
  • Go around the outer edge of the side passive driver with a screwdriver to remove the seven 8.9mm Phillips #00 screws from both sides of the device. Make sure to set the screws aside somewhere they won’t get lost.

Add Comment

Remove the side passive driver. Remove the side passive driver.
  • Remove the side passive driver.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Daley Drucker

Member since: 02/22/2017

774 Reputation

4 Guides authored

Team

USF Tampa, Team S1-G2, Leahy Spring 2017 Member of USF Tampa, Team S1-G2, Leahy Spring 2017

USFT-LEAHY-S17S1G2

5 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 3

Past 7 Days: 35

Past 30 Days: 191

All Time: 848