Repairing Insignia NS-CLIP02 Speaker

Step 1 Motherboard

• Set the clock radio on the work space so the bottom of the device is showing.
Step 2



• Use a metal spudger to peel back the adhesive sticker on the bottom of the clock.
• You should see a single screw beneath the sticker.
Step 3
• Using a plastic opening tool, peel off the adhesive gel stoppers.
Step 4
• Use a Phillips screwdriver to remove the six 11 mm screws on the bottom of the device.
Step 5
• Remove the bottom cover from the device to reveal the motherboard.
Step 6
• Use a Phillips screwdriver to remove the 9.5 mm screw located near the center of the motherboard.
Step 7
• Lift the motherboard away from the device.
Step 8
• Disconnect the four cables connecting the motherboard to the device.
Step 9 Speaker
• Remove the three screws located along the center of the base.
Step 10
• Remove the base from the display.
Step 11
• Using a metal spudger, remove the plastic face plate from the display.
Step 12
• With a phillips screwdriver, remove the six screws shown here.
Step 13
• Next, using the metal spudger, pry the speaker grilles from the display.
Step 14
• Using the phillips screwdriver, remove the four screw seen here.
Step 15
• Separate the two pieces of the display as shown.
Step 16
• You can see that there are several points where connections to the speaker are soldered.
• If all connections are soldered then replacement may be necessary.

Author

with 4 other contributors

Aubrey

Member since: 02/24/15

214 Reputation

2 Guides authored

Badges: 9

• 
• 
• 

+6 more badges

Team

USF Tampa, Team 9-3, Leahy Winter 2015 Member of USF Tampa, Team 9-3, Leahy Winter 2015

USFT-LEAHY-W15S9G3

4 Members

6 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview