Parts

Image 1/2: Use care not to snip the wires. Image 2/2: Use care not to snip the wires.
  • Locate the tie strap holding the wires and cut with a pair of scissors.

  • Use care not to snip the wires.

Add Comment

Image 1/3: Using wire cutters, cut each wire as close to the wire connector as possible. Image 2/3: Cut the wires in both bundles. Image 3/3: To reassemble the cotton candy maker after cutting the wires, follow our [guide|38263|rewiring guide].
  • Make note of the wiring arrangement of each bundle before this step.

  • Using wire cutters, cut each wire as close to the wire connector as possible.

  • Cut the wires in both bundles.

  • To reassemble the cotton candy maker after cutting the wires, follow our rewiring guide.

Add Comment

Image 1/2: Image 2/2:
  • Using the wire stripper, remove 1/2 inch of the wire insulation at the end of each wire to expose the bare wire for re-connection.

Add Comment

Image 1/3: Push the wire cap onto the exposed ends while holding the wires and twist in a clock-wise direction until it is tight. Image 2/3: Repeat this process for both bundles of wires. Image 3/3: Do not attempt to power on the device without the wire caps on or mix wires between the bundles.
  • Twist the exposed ends of the wires so that they stay together.

  • Push the wire cap onto the exposed ends while holding the wires and twist in a clock-wise direction until it is tight.

  • Repeat this process for both bundles of wires.

  • Do not attempt to power on the device without the wire caps on or mix wires between the bundles.

Add Comment

Finish Line

Carlton

Member since: 01/13/2015

621 Reputation

5 Guides authored

Team

USF Tampa, Team 3-5, Hickman Winter 2015 Member of USF Tampa, Team 3-5, Hickman Winter 2015

USFT-HICKMAN-W15S3G5

5 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 187