Repairing HP iPAQ H2200 Faceplates

Step 1 Battery

• Press and slide the battery cover tab to remove battery cover.
Step 2



• Pull on the black tab to lift the battery out of the battery compartment.
Step 3 Main Board
• Remove the stylus by sliding it out of the slot.
Step 4
• Remove the CF card by sliding it out of the slot at the top of the device.
Step 5
• Press down and push the black side strips toward the top of the device to remove them.
Step 6
• Using the T5 Torx screwdriver, remove all six screws on the back and all screws on each side of the device.
Step 7
• Remove the back faceplate by pushing and loosening the 4 side slots (2 on each side).
Step 8
• Open the LCD connector, where the orange strip attaches to the main board.
Step 9
• Carefully remove the orange LCD strip from the connector.
Step 10
• Unscrew the 2 screws located at each top corner of the main board.
Step 11
• Remove the main board by pushing outward on the two tabs located on each side near the bottom of the device.
Step 12 LCD Screen
• Unscrew the two bottom screws on LCD screen that were previously located under the main board.
Step 13
• Press on side tabs to loosen and remove the LCD screen.
Step 14 Faceplates
• Remove the faceplate by unscrewing the green screw located on the top right of the front faceplate.

Author

with 6 other contributors

Tyler Andrews

Member since: 01/13/10

209 Reputation

5 Guides authored

Badges: 7

• 
• 
• 

+4 more badges

Team

Cal Poly, Team 4-12, Forte Winter 2010 Member of Cal Poly, Team 4-12, Forte Winter 2010

CPSU-FORTE-W10S4G12

3 Members

5 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview