Turn off the tablet and disconnect the power and all external devices from the tablet.
  • Turn off the tablet and disconnect the power and all external devices from the tablet.

  • Position the tablet with the display panel down and the right side toward you.

  • Carefully insert a plastic opening tool between the tablet cover and display panel assembly, separating the two components. The first insertion point should be between the power button and the volume buttons.

Add Comment

Slide the tool around the perimeter of the tablet until the edge of the cover is completely separated from the display panel assembly. Slide the tool around the perimeter of the tablet until the edge of the cover is completely separated from the display panel assembly.
  • Slide the tool around the perimeter of the tablet until the edge of the cover is completely separated from the display panel assembly.

Add Comment

Pry open the back cover to take it off. Pry open the back cover to take it off. Pry open the back cover to take it off.
  • Pry open the back cover to take it off.

Add Comment

Deck the Halls
With tools and Fix Kits
Disconnect the battery cables from the system board by desoldering them. See iFixit guide on how to solder. The battery cables are soldered to the system in the following sequence, top to bottom: red, blue, green, yellow, black. The battery cables are soldered to the system in the following sequence, top to bottom: red, blue, green, yellow, black.
  • Disconnect the battery cables from the system board by desoldering them. See iFixit guide on how to solder.

  • The battery cables are soldered to the system in the following sequence, top to bottom: red, blue, green, yellow, black.

Add Comment

Insert a nylon spudger between the battery and the display panel assembly. Carefully  pry the battery up and remove it from its place. The battery is attached to the display panel assembly with double-sided adhesive. Make sure to firmly pull the battery. The regular black nylon spudger should be used whenever possible, especially around batteries.
  • Insert a nylon spudger between the battery and the display panel assembly. Carefully pry the battery up and remove it from its place.

  • The battery is attached to the display panel assembly with double-sided adhesive. Make sure to firmly pull the battery.

  • The regular black nylon spudger should be used whenever possible, especially around batteries.

Add Comment

Use the tweezers to remove the black foam stickers from the rear facing camera to expose the wiring. Use the tweezers to remove the black foam stickers from the rear facing camera to expose the wiring.
  • Use the tweezers to remove the black foam stickers from the rear facing camera to expose the wiring.

Add Comment

Using tweezers, lift the camera out from system board. Using tweezers, lift the camera out from system board.
  • Using tweezers, lift the camera out from system board.

Add Comment

Use tweezers to pull the wire out from the connector. Pull away from the connector, parallel to the tablet. Use tweezers to pull the wire out from the connector. Pull away from the connector, parallel to the tablet.
  • Use tweezers to pull the wire out from the connector. Pull away from the connector, parallel to the tablet.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jessica Andrade

Member since: 10/04/2016

791 Reputation

7 Guides authored

Team

USF Tampa, Team 3-1, Sullivan Fall 2016 Member of USF Tampa, Team 3-1, Sullivan Fall 2016

USFT-SULLIVAN-F16S3G1

3 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 31