Skip to main content

Shop the Holiday Gift Guide
Free Shipping on Domestic Orders $75+

Framework Laptop 16 Webcam Module Installation

Views: 87

View statistics:

Past 24 Hours:
1
Past 7 Days:
4
Past 30 Days:
5
All Time:
87
Comments: 0

No one has left comments on this guide. Will you be first?

Go to guide comments
Completed: 0

No one has marked this guide "completed." Will you be the first?

Favorites: 0

No one has favorited (and subscribed to) this guide. Will you be the first?

Time Required: 10 - 15 minutes
Difficulty: Easy
Prerequisite Only

This is a prerequisite-only guide! This guide is part of another procedure and isn’t meant to be used alone.

Framework Laptop 16 Webcam Module Installation

Introduction

Go to step 1 ↓

Use this guide to replace the webcam, aka "webcam module," in your Framework 16" laptop.

What you need

Tools

  • T5 Torx Screwdriver
    4.9
  • Tweezers
    $4.99
    4.9
  • Spudger
    4.9
    Optional
    1. Framework Laptop 16 Webcam Module Installation, Place the webcam: step 1, image 1 of 2 Framework Laptop 16 Webcam Module Installation, Place the webcam: step 1, image 2 of 2
      • If your replacement webcam comes with liners covering the lenses, remove them now.

      • Place the webcam into its spot above the display, making sure the cable slides into its socket.

      Ask FixBot

      Add Comment

    2. Framework Laptop 16 Webcam Module Installation: step 2, image 1 of 2 Framework Laptop 16 Webcam Module Installation: step 2, image 2 of 2
      • Use the flat end of your Framework Screwdriver, or a clean fingernail, to press down the locking tab on the webcam ZIF connector.

      Ask FixBot

      Add Comment

    3. Framework Laptop 16 Webcam Module Installation, Place the washers: step 3, image 1 of 3 Framework Laptop 16 Webcam Module Installation, Place the washers: step 3, image 2 of 3 Framework Laptop 16 Webcam Module Installation, Place the washers: step 3, image 3 of 3
      • Use your fingers to place the washers into their spots on the Top Cover.

      • The washers only fit one way. If they're aren't fitting properly, flip them over.

      Ask FixBot

      Add Comment

    4. Framework Laptop 16 Webcam Module Installation, Install the webcam screws: step 4, image 1 of 2 Framework Laptop 16 Webcam Module Installation, Install the webcam screws: step 4, image 2 of 2
      • While supporting the screen with one hand, use your Framework Screwdriver to install the two 2.0 mm‑long T5 Torx screws securing the webcam.

      Ask FixBot

      Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers Community for help.

Cancel: I did not complete this guide.

Alex Diaz-Kokaisl

Member since: 01/16/22

252,809 Reputation

1,200 Guides authored

0 Guide Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 4

Past 30 Days: 5

All Time: 87