Framework Laptop 16 Mid Plate Cable Replacement

Unplug all cables and fully shut down your laptop.

Use your fingernail to pull out the two Input Module latches and unlock them.

Use your fingers to slide the Touchpad Spacer toward the bottom edge of the laptop and unclip it.

Lift the Touchpad Spacer off the laptop and remove it.

Repeat the same procedure for the other touchpad spacer.

Use your fingers to slide the Touchpad Module toward the bottom edge of the laptop and disconnect it.

Lift the Touchpad Module and remove it.

Grip the two pull tabs along the bottom of the keyboard and lift until its magnets release.

Remove the keyboard.

Grip the pull tab at the bottom of the Input Module and lift until its magnets release.

Remove the Input Module.

Repeat for any remaining Input Modules.

Grip the black pull tab on the Mid Plate cable press connector.

Lift up to disconnect the Mid Plate cable.

Use your Framework Screwdriver to loosen the 16 captive T5 Torx screws securing the Mid Plate.

Use your fingers to lift the Mid Plate off the laptop and remove it.

Slide the flat end of the Framework Screwdriver under the Mid Plate Cable, near the ZIF connector, to separate the adhesive.

Use the flat end of the Framework Screwdriver, or a clean fingernail, to lift up the locking tab on the Mid Plate Cable ZIF connector.

Use your fingers to grip the black pull tab and slide the Mid Plate Cable straight out of its socket.

Congratulations on completing disassembly! The remaining steps will show how to reassemble your Framework Laptop.

Use your fingers to grip the black pull tab and slide the Mid Plate Cable straight into its socket.

Use the flat end of your Framework Screwdriver, or a clean fingernail, to press down the locking tab on the Mid Plate Cable ZIF connector.

Press the cable to the Mid Plate to re-adhere it.

Place the Mid Plate on the laptop, making sure it sits evenly on its alignment pegs.

Use your Framework Screwdriver to tighten the 16 captive T5 Torx screws in order (starting with 2) to secure the Mid Plate evenly.

Align the Mid Plate cable press connector over its socket and press down to connect it.

Align the top edge of the Input Module with the top edge of the laptop.

Lay the Input Module on the laptop and let the magnets pull the keyboard into place

Repeat for any remaining Input Modules.

Align the top edge of the keyboard with the top edge of the laptop.

Lay the keyboard on the laptop and let the magnets pull the keyboard into place

Place the Touchpad Module flat on its cutout so its clips are properly aligned.

Press the Touchpad Module down and slide it into place so it lines up evenly with the bottom edge of the laptop.

Place the Touchpad Spacer over its spot on the laptop with the bottom edge overhanging slightly.

Slide the Touchpad Spacer towards the top of the laptop to secure it.

Repeat the same procedure for the other Touchpad Spacer.